How to Update Galaxy S Plus 19001 to Jelly Bean 4.2.2 AOKP Custom ROM

The user of Galaxy S Plus 19001 can update it to the Android 4.2.2 AOKP custom ROM and install the Custom ROM using APOK. This tutorial is to guide the user the installation process of the APOK based on Android 4.2.2 for Samsung Galaxy S Plus I9001.

Here are the instructions to install the Android 4.2.2 AOKP Jelly Bean Custom Rom on Galaxy S Plus 19001. Backup your precious data so that after formatting your phone you can have access to the all your data again. Note that this tutorial is only for Samsung Galaxy S Plus 19001.


The Appsteller is publishing this article in the best interest of the user. Please use these tips carefully. We are not liable for any damage or lost caused by any fault or error or any other reason. So be careful.

Follow these additional tips:

Enable USB debugging mode to prevent the problems for connecting your phone to Computer

Download and install the drivers for your Samsung Galaxy S Plus I9001 toyour PC.

Charge your Phone minimum above the 80% of the battery level. If your phone goes off during the installation process, it may results in the dead Phone and this is the very inconvenient for anyone.

The tutorial is for Samsung Galaxy S Plus 19001 and will not work for any other variant so don’t apply this on other devices.


You need to download the APOK Android 4.2.2 Jelly Bean Custom firmware

Time to copy and paste the downloaded Android 4.2.2 ROM Zip file to the SD card. Be careful that the file should be in the SD card Root

Disconnect the device and Switch Off it

Now you have to put you Galaxy S Plus 191001 in the Recovery Mode so turn ON the phone while pressing and holding the Volume Up + Menu + Power buttons same time.

Here you have to tap on the option reading Flash from SD Card followed by selection of choose Zip from SD Card. Locate the firmware Zip file here.

Now confirm the selection in order to start the installation

It will take about a few minute, so be patient and hold on

After successful installation, install the Google Apps by following the same simple and easy to follow procedure

After installation of both firmware and Google Apps, tap on the Go back and then to Reboot System now

Well Done! Now your Galaxy S Plus 19001 should now have Jelly Bean 4.2.2 AOKP custom ROM installed on your Smartphone, Go to Settings > About tablet in order to verify it.

Feel free to contact us and share your experience or any problem using this method if any.

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *